Remembered NETA 2 Questions Help

[Comx10]

I'm thinking motor should stop and stay at highest level. A?

I would have to agree with you there, regardless the motor needs to stop. whether it is A or D. These are the kind of questions that make the NETA test so difficult it seems to. The questions are almost open ended as it seems to me but in the real world it is exact and just go by the book and the manufacturer.

[Vysakh9292]

1.) What is the small notch in a fuse for?

Answer: Rejection Notch

2.) Which has the greatest TIME difference?

Answer a.) Extremely inverse



6.) What is the highest pickup for a low voltage-480 system ground?


Answer: d.) 1200 A

[Vysakh9292]

The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is

A. 20,000
B. 100,000
C. 200,000
D. 1,000,000

[Vysakh9292]

A 12 k resistor, a 15 k resistor, and a 22 k resistor are in series with two 10 k resistors that are in parallel. The source voltage is 75 V. Current through the 15 k resistor is approximately

[A]. 14 mA
[B]. 1.4 mA
[C]. 5 mA
[D]. 50 mA

[Gage1374]

[QUOTE=A_Powers1992;13879]To Whom it May Help:

Here are some questions from my NETA 2 test that I remembered but did not know. All help is greatly appreciated! I did not pass....AGAIN. 406/410. 4 points!!! Third time is charm right? Ugh! Best of luck to you all. You're gonna need it.

1.) What is the small notch in a fuse for?




3.) If a motor and chain are present on an OLTC, once the tap is raised to the highest level and it's still giving a raise signal, what should the OLTC motor do?

a.) motor stop, stay at raised level
b.) motor continue til raise signal is gone
c.) motor continue in reverse til back to neutral
d.) motor stop, cool down

4.) Which XFMR test has the ability to magnetize the windings?

a.) Power Factor
b.) TTR
c.) Excitiation
d.) Zero sequence impedance



6.) What is the highest pickup for a low voltage-480 system ground?

a.) 600 A
b.) 800 A
c.) 1000 A
d.) 1200 A


10.) Testing motor circuits would best be achieved by use of?

a.) Ohmmeter
b.) Phase-angle meter
c.) Ammeter
d.) ???


1) The small nipple on a fuse is to ensure correct sized fused is used.

3) a.) motor stop, stay at raised level

6) d.) 1200 A

10) a.) Ohmmeter